Buzz: it sounds like a beehive in here

July 20, 2012 Laurence Koret

The Problem

Our New York office’s sound system was, frankly, awful. It had a persistent background buzz, a loud hum, which we could not get rid of until we re-engineered our audio cabling.

The Fix

We switched to shielded cabling and professional-grade connectors, and when we finished we no longer heard the buzz. And we are able to drive our sound system with an iPhone.

The 50 foot unshielded cables

In our original setup, we had pulled a 50 foot cable over an air-conditioning duct and lighting fixtures. Even though it was a thick gauge wire, it was not shielded.

[Unshielded wires are susceptible to ground loops and electrical interference. In audio cables, this usually results in a background hum or buzz.]

The cable had a 1/4″ phono plug on both ends. This is a 1950s connector which was used on large headphones and electric guitars. Numerous adapters were cobbled together to connect the sound source to the audio system. The results were uniformly dismal: no matter what we played, no matter how it was connected, it always sounded terrible.

The Final Setup

After some research, we settled on the following:

About the Author


Introducing the UAA and Security for Cloud Foundry
Introducing the UAA and Security for Cloud Foundry

Cloud Foundry is a distributed system with many components front and back end. If you are familiar with the...

Spotlight on Toronto Tech
Spotlight on Toronto Tech

We like to keep tabs on new and innovative ways that technology is being used, especially in Toronto. Here’...

SpringOne 2021

Register Now